Subaru Outback (BR): Wiper and Washer Systems
Subaru Outback (BR) 2010-2015 Service Manual / Body / Wiper and Washer Systems
- General Description of Wiper and Washer Systems
- Wiper and Washer System
- Wiper Blade
- Front Wiper Motor and Link
- Rear Wiper Arm
READ NEXT:
General Description of Wiper and Washer Systems
A: SPECIFICATION
B: COMPONENT
1. FRONT WIPER
Wiper rubber
Wiper blade ASSY
Wiper arm ASSY
Pivot cover B
Wiper link ASSY
Pivot cover C
Wiper motor assembly
Wiper and Washer System
A: WIRING DIAGRAM
1. WIPER AND WASHER (FRONT)
Refer to "Front Wiper and Washer System" in the wiring diagram. <Ref. to
WI-169, WIRING DIAGRAM, Front
Wiper and Washer System.>
2. WIPER AND WASHE
Wiper Blade
A: REMOVAL
1. FRONT
Remove the blade assembly.
1) Lift up the locking clip (A).
2) Turn the blade assembly in the arrow direction.
3) Press the arm in.
4) Pull out the arm while lifting it, and rem
SEE MORE:
Rear Drive Shaft, Reduction Driven Gear
A: REMOVAL
1) Remove the transmission assembly from the vehicle.
<Ref. to 5AT-37, REMOVAL, Automatic Transmission Assembly.>
2) Remove the rear vehicle speed sensor, and then remove the extension case. <Ref. to 5AT-65, REMOVAL, Extension Case.>
3) Pull out the rear drive shaft from c
Basic information about tire pressure monitoring system (TPMS)
The tire pressure monitoring system alerts the driver by transmitting a signal from a sensor in each wheel when tire pressure drops significantly.
This system activates when the vehicle reaches speeds above 20 mph (32 km/h) and may not respond immediately to sudden drops in tire pressure,
© 2010-2026 Copyright www.suoutback.com
