Subaru Outback (BR): Front passenger’s seat (if equipped)
Subaru Outback (BR) 2010-2015 Owners Manual / Seat, seatbelt and SRS airbags / Front seats / Power seat (if equipped) / Front passenger’s seat (if equipped)
1) Seat position forward/backward control switch To adjust the seat forward or backward, move the control switch forward or backward.
2) Seatback angle (reclining) control switch To adjust the angle of the seatback, move the control switch.
READ NEXT:
Head restraint adjustment
1) Head restraint
2) Release button
Both the driver’s seat and the front passenger’s seat are equipped with head
restraints.
The head restraint should be adjusted so that the center of the
Seat heater (if equipped)
1) HIGH – Rapid heating
2) LOW – Normal heating
3) OFF – Off
A) Left-hand side
B) Right-hand side
The seat heater operates when the ignition switch is either in the “Acc” or “ON”
Rear seats
WARNING
Seatbelts provide maximum restraint when the occupant sits well back and upright
in the seat. Do not put cushions or any other materials between occupants and seatbacks
or seat cushions
SEE MORE:
Stop Light Switch
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the instrument panel lower cover.
Remove the clips, and remove the instrument panel side cover LH.
Remove the clips and data link connector, and remove the instrument
panel lower cover under.
Remove the bolts, and remove
High beam light bulbs
1. Remove the air intake duct (right-hand side). For the method to remove the
air intake duct, refer to “Removing air intake duct” F11-7.
Left-hand side
2. Use a screwdriver to remove the secured clip of the washer tank. To make it
easy to access the bulb, move the washer tank to the hor
© 2010-2026 Copyright www.suoutback.com
