Subaru Outback (BR): Recommended shifting speeds
Subaru Outback (BR) 2010-2015 Owners Manual / Starting and operating / Manual transmission / Shifting speeds / Recommended shifting speeds
The best compromise between fuel economy and vehicle performance during normal driving is ensured by shifting up at the speeds listed in the following table.
READ NEXT:
Maximum allowable speeds
WARNING
When shifting down a gear, ensure that the vehicle is not travelling at a speed
exceeding the Maximum Allowable Speed for the gear which is about to be selected.
Failure to observe this p
Driving tips when using a manual transmission
Do not drive with your foot resting on the clutch pedal and do not use the clutch to hold your vehicle at a standstill on an upgrade. Either of those actions may cause clutch damage.
Do not drive w
Automatic transmission/Continuously variable transmission
The automatic transmission is electronically controlled and provides 5 forward
speeds and 1 reverse speed. The continuously variable transmission is electronically
controlled and provides an infin
SEE MORE:
Battery (inspection, removal, installation)
A: REMOVAL
1) After disconnecting the battery ground terminal, remove the terminal cover, then disconnect the positive terminal.
2) Remove the battery cable holder from the battery rod.
3) Remove flange nut from the battery rod and remove battery holder.
Remove the battery.
B: INSTALLATION
Pulling off the fender lining
It is necessary to pull off the fender lining when replacing some bulbs.
1. Start the engine and turn the steering wheel fully in the opposite direction
of the bulb to be replaced.
2. Stop the engine.
3. Remove the clip from the fender lining. Refer to “Type B clips” F11-5.
4. Pull off
© 2010-2026 Copyright www.suoutback.com
