Subaru Outback (BR): Maximum allowable speeds
WARNING
When shifting down a gear, ensure that the vehicle is not travelling at a speed exceeding the Maximum Allowable Speed for the gear which is about to be selected. Failure to observe this precaution can lead to engine over-revving and this in turn can result in engine damage.
In addition, sudden application of engine brakes when the vehicle is travelling on a slippery surface can lead to wheel locking; as a consequence, control of the vehicle may be lost and the risk of an accident increased.
The following table shows the maximum speeds that are possible with each different gear. The tachometer’s needle will enter the red area if these speeds are exceeded.
With the exception of cases where sudden acceleration is required, the vehicle should not be driven with the tachometer’s needle inside the red area. Failure to observe this precaution can lead to excessive engine wear and poor fuel economy.
NOTE
Never exceed posted speed limits.
READ NEXT:
Driving tips when using a manual transmission
Do not drive with your foot resting on the clutch pedal and do not use the clutch to hold your vehicle at a standstill on an upgrade. Either of those actions may cause clutch damage.
Do not drive w
Automatic transmission/Continuously variable transmission
The automatic transmission is electronically controlled and provides 5 forward
speeds and 1 reverse speed. The continuously variable transmission is electronically
controlled and provides an infin
Transmission select lever
The select lever has four positions, “P”, “R”, “N”, “D” and also has a manual gate for using the manual mode.
SEE MORE:
Choosing a child restraint system
Choose a child restraint system that is appropriate for the child’s age and size
(weight and height) in order to provide the child with proper protection. The child
restraint system should meet all applicable requirements of Federal Motor Vehicle
Safety Standards for United States or Canad
DTC P0327, P0328, P0335, P0336, P0340, P0341, P0351, P0352, P0353, P0354,
P0400, P0420
BJ:DTC P0327 KNOCK SENSOR 1 CIRCUIT LOW (BANK 1 OR SINGLE SENSOR)
1. OUTLINE OF DIAGNOSIS
Detect the open or short circuit of knock sensor.
Judge as NG if out of specification.
2. COMPONENT DESCRIPTION
To knock sensor harness
Case
Weight
Piezoelectric element
Nut
Resistance
3. ENABLE CON
