Subaru Outback (BR): P (Park)
This position is for parking the vehicle and starting the engine.
In this position, the transmission is mechanically locked to prevent the vehicle from rolling freely.
When you park the vehicle, first apply the parking brake, then shift into the “P” position. Do not hold the vehicle with only the transmission.
To shift the select lever from the “P” to any other position, you should depress the brake pedal fully then move the select lever. This prevents the vehicle from lurching when it is started.
NOTE
To protect the engine while the “P” position is selected, the engine is controlled such that the engine speed may not become too high even if the accelerator pedal is depressed hard.
READ NEXT:
R (Reverse)
This position is for backing the vehicle. To shift from the “N” to “R” position,
stop the vehicle completely then move the lever to the “R” position.
N (Neutral)
This position is for restarting a stalled engine.
In this position the wheels and transmission are not locked. In this position,
the transmission is neutral; the vehicle will roll freely, even on t
D (Drive)
This position is for normal driving. The transmission automatically shifts into
a suitable gear according to the vehicle speed and the acceleration you require.
When more acceleration is required
SEE MORE:
Security indicator light
The security indicator light deters potential thieves by indicating that the
vehicle is equipped with an immobilizer system. It begins flashing approximately
60 seconds after the ignition switch is turned from the “ON” position to the “Acc”
or “LOCK” position or immediately after
General Description of Trim
A: COMPONENT
1. FRONT UNDER COVER
Small type
Medium type
Large type
Tightening torque: N*m (kgf-m, ft-lb)
T: 17.5 (1.78, 12.9)
2. FLOOR UNDER PROTECTOR
Tightening torque: N*m (kgf-m, ft-lb)
T: 7.5 (0.76, 5.5)
3. FUEL TANK PROTECTOR
Fuel tank protector RH
F
© 2010-2026 Copyright www.suoutback.com
