Subaru Outback manuals

Subaru Outback (BR): Installing carrying attachments on the crossbars

When installing any carrying attachment such as a bike carrier, ski carrier, kayak carrier, cargo basket, etc. on the crossbars, follow the manufacturer’s instructions and make sure that the attachment is securely fixed to the crossbars. Use only genuine SUBARU attachments. A set of the crossbars is designed to carry loads (cargo and attachment) of not more than the allowable load limit described in the Owner’s Manual of a genuine SUBARU carrying attachment. Before operating the vehicle, make sure that the cargo is properly secured on the attachment.

NOTE

● Remember that the vehicle’s center of gravity is altered with the weight of the load on the roof, thus affecting the driving characteristics. Drive carefully, avoid rapid starts, hard cornering and abrupt stops. Crosswind effects will be increased.

● Restore the bars to the original position when the bars are not used as crossbars.

READ NEXT:

 How to use as crossbars

CAUTION ● Do not raise the bar higher than necessary. The base of the bar may be damaged. ● Be careful not to contact the bars while sliding them. Otherwise, the bars may be scratched

 How to re-stow bars

CAUTION Do not use the bars as roof rails when the bars are stowed. 1. Pull out the crossbars from the roof rail holders by pulling up the covers. 2. Slide the bars in the direction shown in th

 Trailer hitch (Outback — if equipped)

WARNING ● Never exceed the maximum weight specified for the trailer hitch. Exceeding the maximum weight could cause an accident resulting in serious personal injuries. Permissible trailer w

SEE MORE:

 Seatbelt and SRS airbag

WARNING ● All persons in the vehicle should fasten their seatbelts BEFORE the vehicle starts to move. Otherwise, the possibility of serious injury becomes greater in the event of a sudden stop or accident. ● To obtain maximum protection in the event of an accident, the driver and a

 HomeLink® Wireless Control System

The HomeLink® Wireless Control System can be used to activate remote control devices such as gate operators, garage door openers, door locks, home lighting and security systems. There are three HomeLink® buttons on the mirror, each of which can be programmed for operation of one desired dev

© 2010-2026 Copyright www.suoutback.com