Subaru Outback (BR): Air inlet selection button (Automatic climate control system)
Select airflow by pressing the air inlet selection button “
”.
ON position (recirculation): Interior air is recirculated inside the vehicle. Press the air inlet selection button to the ON position for fast cooling with the air conditioner or when driving on a dusty road. The indicator light will illuminate.
OFF position (outside Air): Outside air is drawn into the passenger compartment. Press the air inlet selection button to the OFF position when the interior has cooled to a comfortable temperature and the road is no longer dusty. The indicator light will turn off.
WARNING
Continued operation in the ON position (recirculation) may fog up the windows. Switch to the OFF position (outside air) as soon as the outside dusty condition clears.
NOTE
When driving on a dusty road or behind a vehicle that emits unpleasant exhaust gases, set the air inlet selection button to the ON position (recirculation).
From time to time, return the air inlet selection button to the OFF position (outside air) to draw outside air into the passenger compartment.
READ NEXT:
Temperature sensors
1) Solar sensor
2) Interior air temperature sensor
The automatic climate control system employs several sensors. These sensors are
delicate. If they are treated incorrectly and become damaged, t
Cleaning ventilator grille
Always keep the front ventilator inlet grille free of snow, leaves, or other
obstructions to ensure efficient heating and defrosting. Since the condenser is
located in front of the radiator, thi
SEE MORE:
Loading your vehicle
WARNING
Never allow passengers to ride on a folded rear seatback, in the trunk or in
the cargo area. Doing so may result in serious injury.
WARNING
● Never stack luggage or other cargo higher than the top of the seatback because
it could tumble forward and injure passengers in the eve
How to connect and disconnect Airbag Connector
A: PROCEDURE
1. POWER SUPPLY
1) How to disconnect:
CAUTION: When pulling the slide lock or disconnecting connector, be sure to hold the connector, not the harness.
Push the lock (A).
While holding down the lock (A), disconnect the connector.
2) How to connect:
CAUTION: Be sure
