Subaru Outback manuals

Subaru Outback (BR): High beam indicator light

This light shows that the headlights are in the high beam mode.


This light shows that the headlights are in the high beam mode.

This indicator light also illuminates when the headlight flasher is operated.

READ NEXT:

 Indicator light for cruise control in Outback (2010-2015)

  The indicator light for cruise control becomes illuminated upon turning the ignition switch to the “ON” position and remains lit for around 3 seconds. Activation of this light al

 Cruise control set indicator light

The cruise control set indicator light illuminates when the ignition switch is turned to the “ON” position and turns off after approximately 3 seconds. This light illuminates when vehicle spe

 Headlight indicator light

This indicator light illuminates under the following conditions. ● when the light switch is turned to the “” or “” position ● when the light switch is in the “AUTO” posit

SEE MORE:

 Tire Pressure Monitoring System (Diagnostics)

Basic Diagnostic Procedure A: PROCEDURE CAUTION: Before removal or installation, be sure to remove any foreign matter (dust, moisture, oil, etc.) from the TPMS & keyless entry control module connector. NOTE: To check harness for open or short circuits, shake the suspected trouble spot or conne

 Manifold Absolute Pressure Sensor

A: REMOVAL 1) Disconnect the ground cable from battery. 2) Remove the cover (A) and clip (B) from air intake boot assembly. 3) Loosen the clamp (A) which connects the air intake boot assembly and air cleaner case. 4) Loosen the clamp (B) which connects the air intake boot assembly and throttle bo

© 2010-2026 Copyright www.suoutback.com