Subaru Outback (BR): Key number
1) Key number plate
2) Security ID plate
The key number is stamped on the key number plate attached to the key set.
Write down the key number and keep it in another safe place, not in the vehicle. This number is needed to make a replacement key if you lose your key or lock it inside the vehicle.
To make replacement keys, the security ID is also needed. Refer to “Key replacement” F2-4.
READ NEXT:
Immobilizer
The immobilizer system is designed to prevent an unauthorized person from starting
the engine. Only keys registered with your vehicle’s immobilizer system can be used
to operate your vehicle. Ev
Security ID plate
1) Key number plate
2) Security ID plate
The security ID is stamped on the security ID plate attached to the key set.
Write down the security ID and keep it in another safe place, not in the veh
Security indicator light
The security indicator light deters potential thieves by indicating that the
vehicle is equipped with an immobilizer system. It begins flashing approximately
60 seconds after the ignition switch
SEE MORE:
Rear window side seating position
1) Head restraint 2) Release button
To raise:
Pull the head restraint up.
To lower:
Push the head restraint down while pressing the release button on the top of the seatback.
To remove:
While pressing the release button, pull out the head restraint.
To install:
Install the head re
Basic information about tire pressure monitoring system (TPMS)
The tire pressure monitoring system alerts the driver by transmitting a signal from a sensor in each wheel when tire pressure drops significantly.
This system activates when the vehicle reaches speeds above 20 mph (32 km/h) and may not respond immediately to sudden drops in tire pressure,
© 2010-2026 Copyright www.suoutback.com
