Subaru Outback manuals

Subaru Outback: Map light

1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.


1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.

2. Turn the bulb until the flat surfaces at its ends are aligned vertically.


2. Turn the bulb until the flat surfaces at its ends are aligned vertically. Pull the bulb straight downward to remove it.

3. Install a new bulb.

4. Reinstall the lens.

READ NEXT:

 Vanity mirror light

1. Remove the lens by prying the edge of the lens with a flat-head screwdriver. 2. Pull the bulb out of the socket. 3. Install a new bulb. 4. Reinstall the lens.

 Door step light

1. Remove the lens by prying the edge of the lens with a flat-head screwdriver. 2. Pull the bulb out of the socket. 3. Install a new bulb. 4. Reinstall the lens.

 Cargo area light (Outback)

1. Remove the lens by prying the edge of the lens with a flat-head screwdriver. 2. Pull the bulb out of the socket. 3. Install a new bulb. 4. Reinstall the lens.

SEE MORE:

 Rear Wiper Arm

A: REMOVAL 1) Pull up the wiper arm cover. 2) Remove the nut and remove the wiper arm. B: INSTALLATION 1) Install in the reverse order of removal. 2) Operate the rear wiper once. 3) Align the blade with the marking on the glass. Tightening torque: Refer to "COMPONENT" of "General Description".

 Engine Control Module (ECM) I/O Signal

A: ELECTRICAL SPECIFICATION Input/output name: Crankshaft position sensor Camshaft position sensor Measuring condition: After warming-up At idling Engine Condition Data A: ELECTRICAL SPECIFICATION Measuring condition: After engine is warmed up. Set the select lever in "P" range

© 2010-2023 Copyright www.suoutback.com