Subaru Outback (BR): Turn signal indicator lights
Subaru Outback (BR) 2010-2015 Owners Manual / Instruments and controls / Warning and indicator lights / Turn signal indicator lights
These lights show the operation of the turn signal or lane change signal.
If the indicator lights do not blink or blink rapidly, the turn signal bulb may be burned out. Replace the bulb as soon as possible. Refer to “Replacing bulbs” F11-48.
READ NEXT:
High beam indicator light
This light shows that the headlights are in the high beam mode.
This indicator light also illuminates when the headlight flasher is operated.
Indicator light for cruise control in Outback (2010-2015)
The indicator light for cruise control becomes illuminated upon turning the ignition switch to the “ON” position and remains lit for around 3 seconds. Activation of this light al
Cruise control set indicator light
The cruise control set indicator light illuminates when the ignition switch is
turned to the “ON” position and turns off after approximately 3 seconds.
This light illuminates when vehicle spe
SEE MORE:
Engine Mounting
A: REMOVAL
1) Change the front hood damper mounting position
from (A) to (B), and completely open the front
hood.
Tightening torque:
20 N*m (2.0 kgf-m, 14.8 ft-lb)
2) Disconnect the ground cable from battery.
3) Remove the radiator main fan motor assembly
and radiator sub fan motor assembly. <R
Trailer hitch (Outback — if equipped)
WARNING
● Never exceed the maximum weight specified for the trailer hitch. Exceeding
the maximum weight could cause an accident resulting in serious personal injuries.
Permissible trailer weight changes depending on the situation. For possible recommendations
and limitations, refer to
© 2010-2026 Copyright www.suoutback.com
