Subaru Outback manuals

Subaru Outback (BR): Using the cover

To extend the cover, pull the end of the cover out of the housing, then insert


To extend the cover, pull the end of the cover out of the housing, then insert its hooks into the catches as shown. To rewind it, unhook it from the catches and it will rewind automatically. You should hold on to the cover and guide it back into the cover housing while it is rewinding.

WARNING

Do not place anything on the extended cover. Putting excessive weight on the extended cover can break it and an object on the cover could tumble forward in the event of a sudden stop or collision. This could cause serious injury.

CAUTION

● Be careful not to scratch the rear gate stays while extending and rewinding the cover. Scratches on the stays could cause leakage of gas from the stays, which may result in their inability to hold the rear gate open.

● When reclining the rear seatback, move the front cover backward so that the cover is not damaged.

READ NEXT:

 To remove the cover housing

1. Rewind the cover. 2. Hold down the button on the righthand rear quarter panel and lift up the right-hand cover housing. 3. Remove the cover housing.

 Stowage of the cargo area cover

The cargo area cover can be stowed in under the cargo floor. 1. To open the lid, pull the handle up. 2. To keep the lid open, hang the hook (provided on the back of the lid) on the rear edge o

 To install the cover housing

1. To install the cover housing, insert both ends of the cover housing into the retainers. 2. Make sure to fix the front part of the cargo area cover behind the rear seat.

SEE MORE:

 Type B audio set (if equipped)

The audio set will operate only when the ignition switch is in the “Acc” or “ON” position. ● Power and sound controls: refer to page 5-6 ● Radio operation: refer to page 5-9 ● Satellite radio operation (if equipped): refer to page 5-13 ● CD (compact disc) play

 Wheel Alignment (inspection, adjustment)

A: INSPECTION Check the following items before performing the wheel alignment measurement. Tire inflation pressure Uneven wear of RH and LH tires, or difference of sizes Tire runout Excessive play and wear of ball joint Excessive play and wear of tie-rod end Excessiv

© 2010-2026 Copyright www.suoutback.com