Subaru Outback (BR): Automatic Transmission (Diagnostics)
Subaru Outback (BR) 2010-2015 Service Manual / Transmission / Automatic Transmission (Diagnostics)
- Basic Diagnostic Procedure of Automatic Transmission
- Automatic Transmission - List of Diagnostic Trouble Code (DTC)
READ NEXT:
Basic Diagnostic Procedure of Automatic Transmission
A: PROCEDURE
Check List for Interview
A: CHECK
Check the following items when a problem has occurred.
NOTE: Use copies of this page for interviewing customers.
General Description
A: CAUTI
Automatic Transmission - List of Diagnostic Trouble Code (DTC)
A: LIST
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
A: DTC P0705 TRANSMISSION RANGE SENSOR CIRCUIT (PRNDL INPUT)
DTC DETECTING CONDITION:
The inhibitor switch is open or short.
SEE MORE:
Checking the fluid level when the fluid is cold
When the fluid level has to be checked without time to warm up the automatic
transmission, check to see that the fluid level is between the lower level and upper
level on the “COLD” range. If it is below that range, add fluid up to the upper
level. Be careful not to overfill.
CAUTION
Be
Keyless Entry Control Module
A: REMOVAL
1. SEDAN MODEL
1) Disconnect the ground cable from battery.
2) Remove the rear shelf trim. <Ref. to EI-120, REMOVAL, Rear Shelf Trim.>
3) Remove the keyless entry control module.
Disconnect the connector.
Remove the bolt and remove the keyless entry control module.
2. OUTBACK
© 2010-2026 Copyright www.suoutback.com
