Subaru Outback manuals

Subaru Outback: Children

If a child is too big for a child restraint system, the child should sit in the rear seat and be restrained using the seatbelts. According to accident statistics, children are safer when properly restrained in the rear seating positions than in the front seating positions. Never allow a child to stand up or kneel on the seat.

If the shoulder portion of the belt crosses the face or neck, move the child closer to the belt buckle to help provide a good shoulder belt fit. Care must be taken to securely place the lap belt as low as possible on the hips and not on the child’s waist. If the shoulder portion of the belt cannot be properly positioned, a child restraint system should be used. Never place the shoulder belt under the child’s arm or behind the child’s back.

READ NEXT:

 Expectant mothers

Expectant mothers also need to use the seatbelts. They should consult their doctor for specific recommendations. The lap belt should be worn securely and as low as possible over the hips, not ov

 Emergency Locking Retractor (ELR)

The driver’s seatbelt has an Emergency Locking Retractor (ELR). The emergency locking retractor allows normal body movement but the retractor locks automatically during a sudden stop, impact or i

 Automatic/Emergency Locking Retractor (A/ELR)

Each passenger’s seatbelt has an Automatic/ Emergency Locking Retractor (A/ ELR). The Automatic/Emergency Locking Retractor normally functions as an Emergency Locking Retractor (ELR). The A/ ELR

SEE MORE:

 How to use as crossbars

CAUTION ● Do not raise the bar higher than necessary. The base of the bar may be damaged. ● Be careful not to contact the bars while sliding them. Otherwise, the bars may be scratched or the latch portions may be damaged. ● Do not slide the bar more than necessary when sliding

 Side Airbag Sensor

A: REMOVAL 1) Move the seat all the way forward, from which the airbag sensor is to be removed. NOTE: To remove the seat belt retractor assembly. 2) Turn the ignition switch to OFF. 3) Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. 4) Release th

© 2010-2022 Copyright www.suoutback.com