Subaru Outback manuals

Subaru Outback: Seatbelt warning light and chime

Your vehicle is equipped with a seatbelt warning device at the driver’s and front passenger’s seat, as required by current safety standards.

With the ignition switch turned to the “ON” position, this device reminds the driver and front passenger to fasten their seatbelts by the warning lights in the locations indicated in the following illustration and a chime.

Driver’s warning light


Driver’s warning light

Front passenger’s warning light


Front passenger’s warning light

READ NEXT:

 Operation

If the driver and/or front passenger have/ has not yet fastened the seatbelt(s) when the ignition switch is turned to the “ON” position, the seatbelt warning light(s) will flash for 6 seconds,

 SRS airbag system warning light

When the ignition switch is turned to the “ON” position, the SRS airbag system warning light will illuminate for approximately 6 seconds and turn off. This shows the SRS frontal airbag and SRS

 Front passenger’s frontal airbag ON and OFF indicators

The front passenger’s frontal airbag ON and OFF indicators show you the status of the front passenger’s SRS frontal airbag. The indicators are located next to the clock in the center porti

SEE MORE:

 Compass calibration

1. If a “C” is displayed in the compass window, the compass needs to be calibrated. 2. Drive the vehicle in a circle at 5 mph (8 km/h) or less until the display reads a direction. 3. You can also calibrate the compass by driving your vehicle on your everyday routine. The compass will be ca

 High beam light bulbs

1. Remove the air intake duct (right-hand side). For the method to remove the air intake duct, refer to “Removing air intake duct” F11-7. Left-hand side 2. Use a screwdriver to remove the secured clip of the washer tank. To make it easy to access the bulb, move the washer tank to the hor

© 2010-2022 Copyright www.suoutback.com