Subaru Outback (BR): Turn signal indicator lights

These lights show the operation of the turn signal or lane change signal.
If the indicator lights do not blink or blink rapidly, the turn signal bulb may
be burned out. Replace the bulb as soon as possible. Refer to “Replacing bulbs”
F11-48.
READ NEXT:
This light shows that the headlights are in the high beam mode.
This indicator light also illuminates when the headlight flasher is operated.
The indicator light for cruise control becomes illuminated upon turning the ignition switch to the “ON” position and remains lit for around 3 seconds. Activation of this light al
The cruise control set indicator light illuminates when the ignition switch is
turned to the “ON” position and turns off after approximately 3 seconds.
This light illuminates when vehicle spe
SEE MORE:
Precaution
A: CAUTION
Please clearly understand and adhere to the following
general precautions. They must be strictly followed
to avoid minor or serious injury to the person
doing the work or people in the area.
1. VEHICLE DYNAMICS CONTROL (VDC)
Handle the VDC as a total system. Do not disassemble
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the cover (A) and clip (B) from air intake
boot assembly.
3) Loosen the clamp (A) which connects the air intake
boot assembly and air cleaner case.
4) Loosen the clamp (B) which connects the air intake
boot assembly and throttle bo
© 2010-2026 Copyright www.suoutback.com
