Subaru Outback (BR): Mechanical
Subaru Outback (BR) 2010-2015 Service Manual / Engine - H4SO / Mechanical
- General Description of Mechanical
- Engine Assembly
- Engine Mounting
- Timing Belt Cover
- Cam Sprocket
- Cylinder Head
- Cylinder Block
- Oil Switching Solenoid Valve
READ NEXT:
General Description of Mechanical
A: SPECIFICATION
NOTE:
US: Undersize OS: Oversize
B: COMPONENT
1. V-BELT
V-belt
V-belt cover bracket
V-belt tensioner ASSY
Power steering pump bracket
Generator
Engine Assembly
A: REMOVAL
1) Change the front hood damper mounting position
from (A) to (B), and completely open the front
hood.
Tightening torque:
20 N*m (2.0 kgf-m, 14.8 ft-lb)
2) Remove the V-belt covers.
3) C
Engine Mounting
A: REMOVAL
1) Change the front hood damper mounting position
from (A) to (B), and completely open the front
hood.
Tightening torque:
20 N*m (2.0 kgf-m, 14.8 ft-lb)
2) Disconnect the ground cable from
SEE MORE:
Drive Cycle
A: PROCEDURE
It is necessary to perform the drive cycle listed below if DTC is not found
in the Inspection Mode. It is possible
to complete diagnosis of the DTC by performing the indicated drive cycle. After
the repair for the DTC, perform
a necessary drive cycle and make sure the function recover
Clutch Switch
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the instrument panel lower cover. <Ref.
to EI-64, REMOVAL, Instrument Panel Lower Cover.>
3) Disconnect the connector from clutch switch.
4) Remove the clutch switches.
B: INSTALLATION
1. CLUTCH SWITCH
1) Move the clevis pin
© 2010-2026 Copyright www.suoutback.com
