Subaru Outback (BR): Exterior Body Panels
Subaru Outback (BR) 2010-2015 Service Manual / Body / Exterior Body Panels
- General Description of Exterior Body Panels
- Front Hood
- Front Fender
- Front Door
- Rear Door
- Door Sash Tape
- Trunk Lid
- Rear Gate
READ NEXT:
General Description of Exterior Body Panels
A: SPECIFICATION
Refer to Body Repair Manual for the dimensions of the body.
B: COMPONENT
1. FRONT HOOD
Insulator
Front hood panel ASSY
Front grille seal ASSY
Front hood sea
Front Hood
A: REMOVAL
1. FRONT HOOD INSULATOR
Release the clips to remove the front hood insulator.
CAUTION:
Do not reuse any clips damaged during removal. The damaged clip cannot fix the
insulator securely.
T
Front Fender
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the bumper face assembly.
Remove the clips, turn over the front mud guard, and disconnect the fog
light connector. (Model with
f
SEE MORE:
Steering Column
A: REMOVAL
1) Adjust the tilt position to the lowest position and lock the tilt lever.
2) Remove the driver's airbag module assembly.
Push in the snap pin using a hexagon wrench or equivalent wrapped with a
protective tape to disengage
the locks (3 locations).
Disconnect the horn harness a
Oil Seal
A: INSPECTION
Check for transmission gear oil leaks at oil seal area.
If there is an oil leak, replace the oil seal with
new one and check the propeller shaft.
B: REPLACEMENT
1) Remove the collector cover. (turbo model)
2) Lift up the vehicle.
3) Remove the front under cover. <Ref. to EI-35,
© 2010-2026 Copyright www.suoutback.com
