Subaru Outback (BR): Fuel Injection (Fuel Systems)
Subaru Outback (BR) 2010-2015 Service Manual / Engine - H4SO / Fuel Injection (Fuel Systems)
- General Description of Fuel Injection System
- Throttle Body
- Intake Manifold
- Crankshaft Position Sensor
- Knock Sensor
- Manifold Absolute Pressure Sensor
- Oil Temperature Sensor
- Main Relay
- Fuel (tank, pump, sensors)
READ NEXT:
General Description of Fuel Injection System
A: SPECIFICATION
B: COMPONENT
1. INTAKE MANIFOLD
Intake manifold
Gasket
Intake manifold protector RH
Intake manifold protector LH
Fuel gallery RH
Fuel gallery LH
Throttle Body
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the cover (A) and clip (B) from air intake
boot assembly.
3) Loosen the clamp (A) which connects the air intake
boot assembly and ai
Intake Manifold
A: REMOVAL
1. INTAKE MANIFOLD
1) Release the fuel pressure.
2) Disconnect the ground cable from battery.
3) Open the fuel filler lid and remove the fuel filler
cap.
4) Remove the cover (A) and clip
SEE MORE:
Center console box (front)
If you remove the divider plate from the dual cup holders, you can use the center
console box as a storage space.
To use as storage space:
Pull out the divider plate of the dual cup holder.
To use again as cup holders:
Insert the divider plate into the console box.
Woofer
A: REMOVAL
1. SEDAN MODEL
NOTE:
harman/kardon audio system only.
1) Disconnect the ground cable from battery.
2) Remove the rear shelf trim. <Ref. to EI-120, REMOVAL, Rear Shelf Trim.>
3) Remove the woofer.
Remove the screws.
Disconnect the harness connector and remove the woofer assembly
© 2010-2026 Copyright www.suoutback.com
