Subaru Outback manuals

Subaru Outback (BR): Replacing bulbs

WARNING

Bulbs may become very hot while illuminated. Before replacing bulbs, turn off the lights and wait until the bulbs cool down, Otherwise, there is the risk of sustaining a burn injury.

CAUTION

Replace any bulb only with a new bulb of the specified wattage. Using a bulb of different wattage could result in a fire. For the specified wattage of each bulb, refer to “Bulb chart” F12-14.

READ NEXT:

 Headlight

CAUTION Halogen headlight bulbs become very hot while in use. If you touch the bulb surface with bare hands or greasy gloves, fingerprints or grease on the bulb surface will develop into hot spot

 Low beam light bulbs

1. Pull off the fender lining. For details, refer to “Pulling off the fender lining” F11- 7. 2. Remove the bulb cover, by turning it counterclockwise. 3. Disconnect the electrical connecto

 High beam light bulbs

1. Remove the air intake duct (right-hand side). For the method to remove the air intake duct, refer to “Removing air intake duct” F11-7. Left-hand side 2. Use a screwdriver to remove the se

SEE MORE:

 Clutch Disc and Cover

A: REMOVAL 1) Remove the transmission assembly from vehicle body. <Ref. to 6MT-25, REMOVAL, Manual Transmission Assembly.> 2) Attach the ST to the flywheel. ST 499747100 CLUTCH DISC GUIDE Clutch cover 3) Remove the clutch cover and clutch disc. NOTE: Take care not to allow oil to touch

 Door Sash Tape

A: REMOVAL 1. FRONT DOOR 1) Disconnect the ground cable from battery. 2) Remove the front door trim. <Ref. to EI-60, FRONT DOOR, REMOVAL, Door Trim.> 3) Remove the outer mirror assembly. <Ref. to GW-28, REMOVAL, Outer Mirror Assembly.> 4) Remove the sealing cover. CAUTION: Carefull

© 2010-2026 Copyright www.suoutback.com