Subaru Outback (BR): Exterior/Interior Trim
READ NEXT:
A: COMPONENT
1. FRONT UNDER COVER
Small type
Medium type
Large type
Tightening torque: N*m (kgf-m, ft-lb)
T: 17.5 (1.78, 12.9)
2. FLOOR UNDER PROTECTOR
Tightening torque: N
A: REMOVAL
1) Remove the front bumper face assembly.
Remove the clips, turn over the front mud guard, and disconnect the fog
light connector. (Model with
fog light)
Remove the clips at the up
A: REMOVAL
1) Open the front hood.
2) Remove the front wiper arm assembly.
CAUTION:
Follow the steps below when standing up the wiper arm. Not following the steps
may cause contacting
of wiper arms
SEE MORE:
Legacy
Outback
A rear view camera is attached to the trunk lid (Legacy) or rear gate (Outback).
When the ignition switch is “ON” and the shift lever (MT models) or select lever
(AT or CVT models) is set to “R”, the rear view camera automatically displays the
rear view image behin
A: INSPECTION
Check the rear differential mount bushing for
cracks, hardening or damage. If cracking, hardening
or damage is excessive, replace rear differential
mount bushing.
B: REPLACEMENT
CAUTION:
If there was so much rust in the rear differential
mount bushing, remove the rust before
starti
© 2010-2026 Copyright www.suoutback.com
